TchineseEnglish
Your cart contains 1 items
Top » Catalog » Sensors » Encoders » 3530_0 » Optical Rotary Encoder ISC3004 [3530_0]
US$59.44

This encoder can measure rotation at speeds of up to 3000 RPM and plugs into a Phidgets Encoder Interface.

Optical Rotary Encoder ISC3004






This encoder can measure rotation at speeds of up to 3000 RPM and plugs into a Phidgets Encoder Interface.






This is a small ball bearing construction, rotary encoder without index that goes up to 3000 rpm.
The encoder comes with a 1 meter cable and 2 mounting screws.
To attach this encoder to the shaft of a motor or another device, we recommend one of the following shaft couplers:

  • 3420 - Spiral Beam Coupling 4-4mm
  • 3424 - Jaw Coupling Half 4mm



  • Encoder Properties

    Output Circuit Type Push-Pull (Single-Ended)
    Encoder Resolution 360 CPR
    Encoder Speed Max 3000 RPM


    Electrical Properties

    Supply Voltage Min 5 V DC
    Supply Voltage Max 5 V DC
    Output Frequency Max 80 kHz


    Physical Properties

    Shaft Diameter 4 mm
    Shaft Maximum Axial Load 10 N
    Shaft Maximum Radial Load 20 N
    Operating Humidity Min 30 %RH
    Operating Humidity Max (Non-condensing) 85 %RH
    Operating Temperature Min -25 °C
    Operating Temperature Max 85°C
    IP Rating IP54
    Weight 83 g


    This rotary encoder connects to:

  • 1057 - PhidgetEncoder HighSpeed
  • 1047 - PhidgetEncoder HighSpeed 4-Input


  • The easiest way to connect your encoder to the 1057 or to the 1047 is to use a 3019 - HighSpeed Encoder Cable 50cm, cut it to the desired length and solder the encoder wires to the encoder cable as follows:
    The following table shows how to connect the Load Cell Wires to the bridge connectors.


    3530 - Encoder 3019 - Phidget cable
    Red Red
    Black Black
    White White
    Green Brown






    FUNCTIONAL

    You could also buy the male connector, which is a Molex 50-57-9405, and crimp it onto the end of the cable, if you have the appropriate tools.





    This product was added to our catalog on Thursday 02 October, 2014.
    Reviews