|
This compact, economical optical quadrature encoder can be attached
to the 4mm rear shaft of a motor. It has 300 counts (full quadrature
cycles) per rotation and can be installed by fitting it over the shaft,
mounting it to the back of the motor, and tightening the set-screw.
For complete assembly instructions, take a look at the User Guide.
This encoder does not support the use of an index channel.
The mounting holes on the HKT22 encoder line
up with the holes on the back of any rear-shaft stepper motor sold
at Phidgets, Inc. It connects to any of the following interface boards
via the included cable:
1057 - PhidgetEncoder HighSpeed
1047 - PhidgetEncoder HighSpeed 4-Input
Comes Packaged with:
0.9 mm Hex Key for set-screws
Plastic encoder cap and mount
Encoder disk
Encoder PCB
Two screws
3035 - Cable for HKT22 Encoder
|
