The Dual Relay Board allows you to control larger loads and devices
like AC or DC motors, electromagnets, solenoids, and incandescent
Note: This board is not suitable for switching signals. It takes at
least 100mA of current to bridge the oxide layer that forms on the
relay contacts, and most signals will not meet this requirement. If
you need to switch signals, check out the 1017 - PhidgetInterfaceKit
Comes Packaged with:
3002 - 60cm Sensor Cable
If you are looking for a product to do signal
switching see 1017 PhidgetInterfaceKit 0/0/8.
We also have a 4-Relay board that can plug directly
into your PC. See the 1014 ¡V PhidgetInterfaceKit 0/0/4.