Your cart contains 0 items
Top » Catalog » Controllers » LEDs » 1032_0 » PhidgetLED-64 Advanced [1032_0]

This Phidget uses PWM to control the brightness of up to 64 LEDs.

PhidgetLED-64 Advanced

This Phidget uses PWM to control the brightness of up to 64 LEDs.

The PhidgetLED 64 allows you to independently control 64 Light Emitting Diodes. Each LED can have the current limit set individually, and the brightness controlled from 0 to 100% within that limit using pulse-width modulation. These LED outputs can also be used to interface other devices that benefit from pulse width modulation (such as buzzers, fans, and other small, simple electronics).

Most standard LEDs have forward voltages below 2.75 Volts, and can be used with the PhidgetLED by simply soldering them to a connector-wire and inserting the wire into any PhidgetLED board output. The forward voltage will default to 2.75V, and the maximum current defaults to 20mA.

Comes Packaged with:

  • A 3018 - Mini-USB Cable 180cm
  • 3021 - 16 Double Ended cables
  • A 12VDC, 2A Power Supply
  • A Hardware mounting kit
  • Note: Cut the Double Ended cables in half and solder the cut end to the LED. Check the Getting Started section of the User Guide for more detailed information.

    Physical Properties

    API Object Name LED
    Number of LED Outputs 64
    Recommended Wire Size (Power Terminal) 12 to 26 AWG
    Power Jack 5.5 x 2.1mm Center Positive
    Operating Temperature Min -40 °C
    Operating Temperature Max 85 °C

    Electrical Properties

    Current Consumption Min 70 mA
    Supply Voltage Min 6 V DC
    Supply Voltage Max 15 V DC
    PWM Resolution 12 bit
    PWM Frequency Max 1 kHz
    Selectable Output Voltage Levels 1.7, 2.75, 3.9, 5.0 VDC
    Output Current Limit Max (Per LED) 80 mA
    LED Current Limit Max 80 mA
    LED Current Limit Resolution 1.3 mA
    USB Speed Full Speed

    This product was added to our catalog on Thursday 09 October, 2014.